The new version (just released) of CiscoWorks (ver.2.2) includes PIX management capability as well as the already established router/VPN management. Its not cheap though. -----Original Message----- From: Lorens Kockum [mailto:firewall-wizards-20021015at_private] Sent: Friday, October 25, 2002 5:22 AM To: DocValdeat_private; firewall-wizardsat_private Subject: Re: [fw-wiz] wanted: Cisco PIX Management Tool On Tue, Oct 22, 2002 at 03:06:33PM +0200, DocValdeat_private wrote: > > Right now, i know three possibilities to manage them: > > 1. Command Line Interface > 2. Cisco PIX Device Manager > 3. Cisco Secure Policy Manager 3.x ... > Does anybody know any third-party products for these tasks? Investigate Net Partitioner (http://www.solsoft.com/). They (disclaimer: ex-we) support PIX and a load of other devices. Define your network, tell NP that that device is a PIX, that one too, that one a router w/o filters, etc., define your policy, compile, upload filters. Exercise left to reader : PIX catches fire, no replacement PIX, replace with other supported device, tell NP (10 seconds), recompile (20 seconds), reupload. Compare time necessary to rewrite PIX rules, even using sed, for something non-IOS. Payware (probably lots of $$$ for your config), but gratis time-limited demo. HTH. -- #include <std_disclaim.h> Lorens Kockum _______________________________________________ firewall-wizards mailing list firewall-wizardsat_private http://honor.icsalabs.com/mailman/listinfo/firewall-wizards _______________________________________________ firewall-wizards mailing list firewall-wizardsat_private http://honor.icsalabs.com/mailman/listinfo/firewall-wizards
This archive was generated by hypermail 2b30 : Fri Oct 25 2002 - 09:24:43 PDT